Modify your Winware End GCode to present your print on your Winbo Super Helper

Are you fed up of having to move your build platform on your Super Helper after a print to access your printed item? Well this little mod will move the print head up and away from your print and move the build platform forward to make it easier to remove.

In Winware click on the "Start/End-GCode" tab, then click end.gcode, and modify the displayed GCode to the following:-

;End GCode
G91
;{end_action}
G4 P2
;G28 X0 Y0
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+20 E-5 X-20 Y+20 F0 ;move Z up a bit and retract filament even more
G28 X0 ;move X to min endstops, so the head is out of the way
M140 S0
M104 S0
;{end_extrusion}
;{step_unlock}
G90
G1 Y+108 ;move Y to max endstops, so the printbed is accessable
;{profile_string}

 

And hey presto the next time you generate a GCode file using Winware it will add these instruction to it and present you your print once finished.

 


Leave a comment

Please note, comments must be approved before they are published